9krpmrx8's Boost Build Thread
#76
SARX Legend
Thread Starter
iTrader: (46)
![TX](https://www.rx8club.com/images/icons/tx.jpg)
Gotcha, I am just wondering if one of the shorter but thicker core units would be sufficient enough, that would be ideal because it would allow more flow to the radiator.
Does anyone have the specs of the Greddy Intercooler?
Last edited by 9krpmrx8; 04-06-2011 at 10:57 PM.
#78
SARX Legend
Thread Starter
iTrader: (46)
^ Thanks. I was searching last night and found the same bar and plate intercooler that comes in the Hymee kit for under $100.00. Bar and plate intercoolers are supposedly the best so my question is are the ones that cost three times as much really better?
I realize construction is a key factor but having the one from the Hymee in my hands I can say that it appears to be constructed really well.
I realize construction is a key factor but having the one from the Hymee in my hands I can say that it appears to be constructed really well.
#91
Registered
iTrader: (1)
I will check to see if I have a high res photo.
They might of gone bye bye when my last computer died.
The crash bar mounts were left in place and a smaller tube was welded to it.
The tube also acts as a mount for the tow hook.
I kept the templates that the fabricator used for the ducting
in case I had to duplicate it. The vented hood and Mazdaspeed front nose helped a bit. I would guess that these mods dropped the track water temps 15 degrees.
They might of gone bye bye when my last computer died.
The crash bar mounts were left in place and a smaller tube was welded to it.
The tube also acts as a mount for the tow hook.
I kept the templates that the fabricator used for the ducting
in case I had to duplicate it. The vented hood and Mazdaspeed front nose helped a bit. I would guess that these mods dropped the track water temps 15 degrees.
#95
SARX Legend
Thread Starter
iTrader: (46)
Okay. So, I'm not sold on upgrading to the BNR or just replacing it for a ball bearing turbo all together. I just don't think I need that level of power to meet my goals with the car.
If I were to get the Greddy rebuilt would going with a different WG actuator be better than doing the mod to the WG Brettus did?
If I were to get the Greddy rebuilt would going with a different WG actuator be better than doing the mod to the WG Brettus did?
#96
Turbo Member
iTrader: (10)
I dont think that the stock wastegate is bad. Most people do not do what bettus did. Normally people run a BC. I have not seen any reports of a failed greddy actuator.
My kit came with a modified external wastegate and I will be reverting back to the stock wastegate.
hope this helps ya out
My kit came with a modified external wastegate and I will be reverting back to the stock wastegate.
hope this helps ya out
#99
Registered
iTrader: (1)
Congrats on making the push 9k! Can't wait to see how this turns out.
The problem with the actuator isn't that it fails. It's that the actuator isn't strong enough to hold itself closed in the upper rpm because of the high exhaust pressure. This results in lower boost pressure up top and when this happens, even a boost controller won't help since it can't control the position of the actuator arm.
The problem with the actuator isn't that it fails. It's that the actuator isn't strong enough to hold itself closed in the upper rpm because of the high exhaust pressure. This results in lower boost pressure up top and when this happens, even a boost controller won't help since it can't control the position of the actuator arm.