Brettus NA power project
#376
Rotary Crawfish
Hey Brett, what was that 4 door you lined up with? Looks like a GLC that used to be sold in the states.
Bluey is very nice looking, if it wasn't so darn hot here I might repaint mine that color.
Bluey is very nice looking, if it wasn't so darn hot here I might repaint mine that color.
#378
Had a bad experience with this car recently when I got stuck in traffic on a hot day. After several minutes of a nice pulsing idle like it normally does, it stopped pulsing and started surging instead. Several more minutes passed and then the water temp warning buzzer went off on my gauge. Temperature kept climbing and reached around 105C before it stabilised. No good!
When I got home, and after some deliberation, I decided to remove the stock air intake tray to allow more flow for the fans. That meant the AEM style intake was taking the full flow of air from the fans so I fitted some heat shielding around the intake/maf tubes as well.
Today I finally got around to testing whether this has done the trick .... ambient temp. was 29C. I went for a drive and when I got back left the car to idle. After about 5 min. the temp. had gone past the low speed setting and hit the high speed fan setting (95C on this car). Was happy to see that the water temp now goes down when the high speed fans kick in. Not only that , but the nice rotary pulsing idle was retained.
So .......problem solved!
When I got home, and after some deliberation, I decided to remove the stock air intake tray to allow more flow for the fans. That meant the AEM style intake was taking the full flow of air from the fans so I fitted some heat shielding around the intake/maf tubes as well.
Today I finally got around to testing whether this has done the trick .... ambient temp. was 29C. I went for a drive and when I got back left the car to idle. After about 5 min. the temp. had gone past the low speed setting and hit the high speed fan setting (95C on this car). Was happy to see that the water temp now goes down when the high speed fans kick in. Not only that , but the nice rotary pulsing idle was retained.
So .......problem solved!
The following 2 users liked this post by Brettus:
RotaryMachineRx (01-09-2024),
wannawankel (01-09-2024)
The following 2 users liked this post by Brettus:
kevink0000 (02-19-2024),
RotaryMachineRx (02-23-2024)
Thread
Thread Starter
Forum
Replies
Last Post
rtjhe
Series I Aftermarket Performance Modifications
24
06-08-2010 08:29 PM
Lasse wankel
Series I Major Horsepower Upgrades
134
01-29-2009 01:25 AM
Velocity Rx8
Series I Aftermarket Performance Modifications
37
07-21-2005 07:33 PM