OMP and boost. A potential problem.
#26
Administrator
iTrader: (7)
MM needs to work for MNAO....
#27
Best bet is to use one of the existing nipples on the lower manifold.
That way, any oil that goes the wrong direction will not spray down the entire inside of your manifold.
That said, you probably don't need to worry about any of this. I suggest you do the vacuum test on your nozzles. If they hold a vacuum, don't do anything.
That way, any oil that goes the wrong direction will not spray down the entire inside of your manifold.
That said, you probably don't need to worry about any of this. I suggest you do the vacuum test on your nozzles. If they hold a vacuum, don't do anything.
#29
So we need to seek out the "Flying Spaghetti Monster" (FSM) for the procedure??
Good thing I'm a pastafarian!
RAMEN!!
#31
Registered
Let us know if you find a reason for the other check valves not working.
Sounds like the system would be happier with clean oil being fed to it rather than what it gets stock. That may be a compromise high performance owners may want to address.
Waiting on the edge of my seat MM!
Sounds like the system would be happier with clean oil being fed to it rather than what it gets stock. That may be a compromise high performance owners may want to address.
Waiting on the edge of my seat MM!
Last edited by jeffe19007; 05-25-2007 at 11:03 PM.
#32
Well, I vac tested them all (and the nozzles in the current engine) and I'm 50% on them.
All of the nozzles in the current motor check out and 2 out of the previous 8 do as well.
Soaking them with carb cleaner did nothing, but that might change after a few days.
I'll hit them with some high-pressure air and see if they snap shut.
This would be a very tiny vacuum leak under normal circumstances.
All of the nozzles in the current motor check out and 2 out of the previous 8 do as well.
Soaking them with carb cleaner did nothing, but that might change after a few days.
I'll hit them with some high-pressure air and see if they snap shut.
This would be a very tiny vacuum leak under normal circumstances.
#36
sometimes this doesnt work, and capping them off does. its confusing.
http://www.rx7club.com/showthread.ph...etering+nozzle
http://www.rx7club.com/showthread.ph...light=metering
#37
13B-RE
iTrader: (1)
I have a plan and I'm ready to test it but I do have a question. Of the two hoses that go below the manifold(OMP and FI) Which one is the one for the OMP? They both have a small painted rectangle on them, one is white and the other is yellow. Which is which? Let me know. Thanks
Esmeril
Esmeril
#39
#43
Yup, pan goes in todayn after i get work. then I'll have to go hunting for that one last thing.
If I find it I might dive over. But i'll do some driving around my place first ..
All I can think of is that dam oil pan and i am done hehehe. Here I am at sitting on my butt at work.
Give Ted a call. He does not work until 4 and he have a shop manual
Thread
Thread Starter
Forum
Replies
Last Post
Shankapotamus3
Series I Trouble Shooting
28
03-14-2021 03:53 PM
05rx8mazda
RX-8 Parts For Sale/Wanted
18
11-28-2015 09:42 AM
tommy26Germany
Series I Trouble Shooting
11
09-29-2015 10:33 AM