RX-7 FD3S REW-13B on RX-8
10-27-2009 | 12:44 PM
#27
i'm the undead
Joined: Jul 2004
Posts: 254
Likes: 0
Km/h speedo, eh?
well, whether it's his car or not, i think it's still pretty cool. i'd rather keep my current Rx-8 based on the Renesis, but if i were to get a second Rx-8, i'd more than likely put an REW or RE in it.
well, whether it's his car or not, i think it's still pretty cool. i'd rather keep my current Rx-8 based on the Renesis, but if i were to get a second Rx-8, i'd more than likely put an REW or RE in it.
02-06-2011 | 01:49 PM
#28
tuner boy
Joined: Feb 2009
Posts: 39
Likes: 0
From: spokane, wa
This 8 was original a 4AT with turbo. The power it has tranny just could not hold. There were lots problems. So easiest way to get more power and stay rotary is upgrade to RX-7 REW-13B. It uses original RX-7 5 speed tranny. Custom engine subframe. Cuz RX-8 engine sits little more backward. HKS F-Con V Pro (3.24B) on RX-8 factory ECU. Single turbo is base on Garrett M24/AR60 BB. But I think it is too small. Custom drive shaift.
02-06-2011 | 02:16 PM
#29
KDR has done this as well ... they are using interceptor-X and stock ECU to run it .... IMO Int-X + Stock ECU + COBB(to block CEL's) can be used as well ... it would be a very PAITA set-up but it could be done if you need to retain OBD2
Thread
Thread Starter
Forum
Replies
Last Post
Tsurugi
New Member Forum
0
09-07-2015 09:27 PM
SBGarage
Vendor Classifieds
0
09-06-2015 04:30 PM
SBGarage
Sakebomb Garage
0
09-06-2015 04:29 PM
