The Turblown Low Mount Turbo System
#52
Thanks. What I am also trying to clarify is that both grounds will go to both sensors, while the IAT hot wire only goes to the MAF I am using for IAT. Is this correct?
#55
Looking for advice on my base tune. I plan to go Adaptronic shortly, but wanted something relatively "safe" so I could drive the car now. AccessTuner Race file and a data log are attached. The log was just a sample to see what fueling and ignition looked like under boost. I don't expect that my MAF is dialed in. Flame suit is on so fire away but constructive criticism is definitely appreciated...
#57
#58
Registered
iTrader: (25)
Looking for advice on my base tune. I plan to go Adaptronic shortly, but wanted something relatively "safe" so I could drive the car now. AccessTuner Race file and a data log are attached. The log was just a sample to see what fueling and ignition looked like under boost. I don't expect that my MAF is dialed in. Flame suit is on so fire away but constructive criticism is definitely appreciated...
#63
Hey all, sorry for not updating here. I am putting this Turblown low mount kit up for sale. I started out on this quest as a winter project for earlier this year to be driving this summer, but it went longer than I anticipated. Now that I finally have nice summer weather I am enjoying the car too much to tear her apart again. I will post in the for sale section. If it doesn't sell then it will likely become a project for next winter...
Elliot has been great and really took care of things, THANK YOU ELLIOT! He even told me he would extend the warranty to the buyer. He also said the current wait time is about 12 weeks, so if someone wants one now this one is ready to go... Look in the for sale section shortly...
Elliot has been great and really took care of things, THANK YOU ELLIOT! He even told me he would extend the warranty to the buyer. He also said the current wait time is about 12 weeks, so if someone wants one now this one is ready to go... Look in the for sale section shortly...
#65
Lucky #33
iTrader: (4)
Hey all, sorry for not updating here. I am putting this Turblown low mount kit up for sale. I started out on this quest as a winter project for earlier this year to be driving this summer, but it went longer than I anticipated. Now that I finally have nice summer weather I am enjoying the car too much to tear her apart again. I will post in the for sale section. If it doesn't sell then it will likely become a project for next winter...
Elliot has been great and really took care of things, THANK YOU ELLIOT! He even told me he would extend the warranty to the buyer. He also said the current wait time is about 12 weeks, so if someone wants one now this one is ready to go... Look in the for sale section shortly...
Elliot has been great and really took care of things, THANK YOU ELLIOT! He even told me he would extend the warranty to the buyer. He also said the current wait time is about 12 weeks, so if someone wants one now this one is ready to go... Look in the for sale section shortly...
WOW that was quick..... I hate it when i see people give up. It really should not take more then a few weekends to get the kit installed.
#67
Here's some photos from when it was installed, since people had asked.
Last edited by slash128; 06-29-2012 at 01:22 PM. Reason: Adding photos
The following users liked this post:
rob babicki (06-14-2021)
#71
No, the MAF sensor you see in the pic just before the TB is only used for IAT. The actual MAF sensor for airflow is in the intake over the crash bar. You can't see it in that photo. If you look at the photo where the intake is point up you'll see a shiny section after the filter. That is the MAF housing.