any DIY for Pulley set install?
#4
WAH WAH WAH
iTrader: (8)
Join Date: Mar 2008
Location: BK/Rockland County
Posts: 1,854
Likes: 0
Received 0 Likes
on
0 Posts
Ha i had a bit of trouble with that as well. I soaked the 4 bolts in pb blaster after and after i took them out the stock pulley seemed like it was welded on (it wasnt). I took a blogk of wood and placed it on the pulley and tapped it with a rubber mallet. that didnt seem to work but it actually did move the pulley just enough for me to slip a flat head screw driver between and tap the edge with a mallet to pop of the pulley. I had to turn the crank shaft to make sure the pulley came off even because there is basically a sleeve that the pulley slides onto.
Thread
Thread Starter
Forum
Replies
Last Post
bulletproof21
RX-8 Parts For Sale/Wanted
6
10-20-2015 08:53 PM