Notices
Series I Tech Garage The place to discuss anything technical about the RX-8 that doesn't fit into any of the categories below.

Blinking Exclamation Mark?

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 11-30-2012, 09:17 AM
  #1  
Registered User
Thread Starter
 
-mandy-'s Avatar
 
Join Date: Nov 2012
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
Blinking Exclamation Mark?

I just bought a 2005 RX-8 yesterday. Not until I was almost home (2 hour drive) did I realize there was a yellow exclamation mark blinking. By that time, the dealer was closed. A friend told me to check my tire pressure...they are all 30 lbs. How much air should be in the tires? Is that why the light is blinking or could it be something else?
Old 11-30-2012, 09:19 AM
  #2  
FULLY SEMI AUTOMATIC
iTrader: (9)
 
200.mph's Avatar
 
Join Date: Aug 2008
Location: BALLS DEEP
Posts: 5,639
Received 2,366 Likes on 1,995 Posts
sounds like tpms light. check tire pressure. i think factory is ~32
Old 11-30-2012, 09:23 AM
  #3  
USMC
iTrader: (3)
 
Johnvx1k's Avatar
 
Join Date: Dec 2011
Location: Wilmington, NC
Posts: 368
Likes: 0
Received 1 Like on 1 Post
If the light stays on solid, then it means the tire pressure is too low or too high. If it is blinking, then it means there is a malfunction with the TPMS. Mine did this recently as well. Most likely one of the sensors has gone bad and that is why it is blinking. You can leave it as it is and just check your tire pressure regularly or bring it to a dealer and they can find out which ones are bad.
Old 11-30-2012, 09:41 AM
  #4  
Out of NYC
iTrader: (1)
 
nycgps's Avatar
 
Join Date: Jun 2005
Location: Planet Earth
Posts: 19,881
Received 32 Likes on 30 Posts
if tire pressure is right, then one or more sensor has gone bad.


tpms has a design life of around 10 yrs or around 100k ?miles. but hey it can be more it can be less.
Old 11-30-2012, 11:36 AM
  #5  
Registered
 
j9fd3s's Avatar
 
Join Date: May 2003
Posts: 1,382
Likes: 0
Received 11 Likes on 10 Posts
the tire sticker in the door jamb says 32psi. they don't specify hot or cold, but since air expands when its hot, i like to set it to 32psi cold.

the blinking can be intermittent so set the pressures first, but its likely to be a failing sensor. the good news is that labor is small to put the sensor in. i just had one done and the labor was $30.00. sensor is like $55-70 depending on where you buy
Old 11-30-2012, 11:42 AM
  #6  
Registered User
Thread Starter
 
-mandy-'s Avatar
 
Join Date: Nov 2012
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
Thank you guys...I appreciate the help!
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
WranglerFan
New Member Forum
4
05-31-2022 07:51 AM
SUKIEE
New Member Forum
19
10-09-2017 09:41 PM
MANIACman
New Member Forum
7
11-11-2015 10:58 PM
XianUnix
Series I Trouble Shooting
6
09-29-2015 03:48 PM
Rx808BI
New Member Forum
4
08-09-2015 10:06 AM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.

Quick Reply: Blinking Exclamation Mark?



All times are GMT -5. The time now is 08:17 PM.