ECU Reset!
05-02-2010, 02:37 PM
#1
Registered
Thread Starter
Join Date: Mar 2010
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
ECU Reset!
I have recently purchased a JDM `04 RX8 (4-PORT)
I have replaced ignition coils and plugs.
I have done this after disconnecting the battery negative terminal (I know it is not required, but I have done it for extra safety).
After reconnecting battery I have also recalibrated DSC.
The card started normally, however it kept stalling and idle was wierd. This occured for the first 2/3km and afterwards it started to idle better.
Is this something normal? Can anyone please explain? ... I thought it was due to the PCM to relearn... however I still find it hard to beleive that PCM doesn`t have base maps for reference in order to operate correctly when in open loop!!
Any insights would be appreciated!
I have replaced ignition coils and plugs.
I have done this after disconnecting the battery negative terminal (I know it is not required, but I have done it for extra safety).
After reconnecting battery I have also recalibrated DSC.
The card started normally, however it kept stalling and idle was wierd. This occured for the first 2/3km and afterwards it started to idle better.
Is this something normal? Can anyone please explain? ... I thought it was due to the PCM to relearn... however I still find it hard to beleive that PCM doesn`t have base maps for reference in order to operate correctly when in open loop!!
Any insights would be appreciated!
Thread
Thread Starter
Forum
Replies
Last Post