Help Identify This Part...
#1
Registered
Thread Starter
iTrader: (4)
Join Date: Jul 2007
Location: Des Moines, Ia
Posts: 950
Likes: 0
Received 0 Likes
on
0 Posts
Help Identify This Part...
I dont happen to have any pictures of this part but i am in the process of putting hte motor back in the 8. I distinctly remember a small electrical part that i can not find. I am purely going of off memory here so if anyone can tell me what it is and/or what it does i would appreciate it.
What i remember is this: The main wiring harness for the engine is bolted to the top of hte motor via the metal bracket the harness is connected to. I believe that bolted to one of these same holes was a small gray 1/2" by 1/2" box. It had wires coming off it that plugged into the harness via a small black two prong connector (i think) and a ring/washer type attached to it so it could be bolted to the block along with the metal bracket for the harness.
I may have found it in a part book. number N3A1-66-991
After a little searching it says its a condensor. What does it do?
Thanks for hte help guys. and i know its a very bad description.
What i remember is this: The main wiring harness for the engine is bolted to the top of hte motor via the metal bracket the harness is connected to. I believe that bolted to one of these same holes was a small gray 1/2" by 1/2" box. It had wires coming off it that plugged into the harness via a small black two prong connector (i think) and a ring/washer type attached to it so it could be bolted to the block along with the metal bracket for the harness.
I may have found it in a part book. number N3A1-66-991
After a little searching it says its a condensor. What does it do?
Thanks for hte help guys. and i know its a very bad description.
Last edited by Phish806; 07-30-2010 at 09:27 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Shankapotamus3
Series I Trouble Shooting
28
03-14-2021 03:53 PM
JimmyBlack
Series I Major Horsepower Upgrades
273
02-10-2020 10:23 PM