K&N air intake installation question
#1
Registered
Thread Starter
Join Date: Jul 2010
Location: Huntington Beach, CA
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
![WA](https://www.rx8club.com/images/icons/wa.jpg)
I successfully installed the air intake filter to my 8 but i have some questions about the pipes(see attached picture). It is touching the AC compressor ( i think ), and it is kind of loose at the end where it is attached to the intake tube.
![](http://img20.imageshack.us/img20/3783/23273864.th.jpg)
![](http://img269.imageshack.us/img269/5404/68719483.th.jpg)
questions:
>Is it safe touching the AC compressor? (I'm worried it will melt)
>should i put hose clamp on the loose end (intake tube) ?
Any input will be very much appreciated.
Regards,
Chris
![](http://img20.imageshack.us/img20/3783/23273864.th.jpg)
![](http://img269.imageshack.us/img269/5404/68719483.th.jpg)
questions:
>Is it safe touching the AC compressor? (I'm worried it will melt)
>should i put hose clamp on the loose end (intake tube) ?
Any input will be very much appreciated.
Regards,
Chris
Thread
Thread Starter
Forum
Replies
Last Post
jay_tibo
Series I Aftermarket Performance Modifications
22
09-13-2016 08:10 PM