Notices
Series I Tech Garage The place to discuss anything technical about the RX-8 that doesn't fit into any of the categories below.

Is it normal for an RX-8 to NOT burn any oil? If not, WTF might be wrong?

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 04-29-2014 | 04:44 PM
  #1  
dezau's Avatar
Thread Starter
Registered
iTrader: (3)
 
Joined: Mar 2009
Posts: 1,711
Likes: 2
From: Windermere, FL
Is it normal for an RX-8 to NOT burn any oil? If not, WTF might be wrong?

Now I've had my car since Mar 09', and have had like 3 engines replaced now. All of them lasted around 10k miles and 18 months. 2 of them were replaced by warranty, and this new one that I got was built by Pettit.

The thing that suddenly hit me today though was I seldom had to oil. I can count by my fingers for the number of times that I actually needed to add oil. I check my oil level regularly. So wtf? I thought we were supposed to burn some oil.

What could be wrong with the car? Could it be down to driving habits? I used to drive all city and short trips. Recently since I've moved, I started putting some hwy miles on it.
Old 04-29-2014 | 04:45 PM
  #2  
9krpmrx8's Avatar
SARX Legend
iTrader: (46)
 
Joined: Jan 2007
Posts: 33,786
Likes: 455
From: San Antonio, Texas
Not normal and a lack of oil consumption is bad.

https://www.rx8club.com/series-i-tec...theory-210194/
Old 04-29-2014 | 04:47 PM
  #3  
Chrishoky's Avatar
Registered
iTrader: (9)
 
Joined: May 2010
Posts: 1,186
Likes: 48
From: North Wales, PA
Could be the reason you are through 3 engines already. If the omp is not lubricating the engine properly you would see premature wear throughout. Could be something to look into. I add about half a quart every two fill ups on my 05, which is on its second engine.
Old 04-29-2014 | 04:49 PM
  #4  
9krpmrx8's Avatar
SARX Legend
iTrader: (46)
 
Joined: Jan 2007
Posts: 33,786
Likes: 455
From: San Antonio, Texas
The function of cooling the side seals that the OMP provides is as important or even more important than the lubrication side of it.
Old 04-29-2014 | 05:01 PM
  #5  
dezau's Avatar
Thread Starter
Registered
iTrader: (3)
 
Joined: Mar 2009
Posts: 1,711
Likes: 2
From: Windermere, FL
Well... in that case, it's nice that I started pre-mixing with this engine... What... should I be looking at exactly, not exactly mechanically savvy here. Just did my first oil change in Feb...
Old 04-29-2014 | 05:03 PM
  #6  
RIWWP's Avatar
Registered
iTrader: (2)
 
Joined: Oct 2007
Posts: 16,684
Likes: 261
From: Pacific Northwest
Sounds like you need to flush your OMP lines and oil injectors before you lose this engine too. Premixing will NOT save the side seals, you still need the OMP for that.

I recommend adding a SOHN adapter as well, so you can more accurately watch the oil consumption rates, and to prevent the lines from getting clogged again (which dirty 4-stroke will do)
Old 04-29-2014 | 10:15 PM
  #7  
TeamRX8's Avatar
Registered
iTrader: (25)
 
Joined: Apr 2005
Posts: 26,869
Likes: 2,083
Don't see it ever mentioned much, but there is a RTFM procedure for vacuum testing the oil injectors
Old 04-30-2014 | 12:25 PM
  #8  
j9fd3s's Avatar
Registered
 
Joined: May 2003
Posts: 1,382
Likes: 11
given 3,000mile oil changes, if you don't drive hard, and the engine is in good shape you won't have to add oil.
Old 04-30-2014 | 12:27 PM
  #9  
RIWWP's Avatar
Registered
iTrader: (2)
 
Joined: Oct 2007
Posts: 16,684
Likes: 261
From: Pacific Northwest
I disagree with the "and the engine is in good shape". The condition of the engine won't affect the OMP injection rate. Yes, it's possible to drive lightly enough to not burn through a quart of oil over 3,000 miles, but then you have other problems, like carbon choking.


I seriously doubt he is driving that lightly.
Old 04-30-2014 | 01:13 PM
  #10  
9krpmrx8's Avatar
SARX Legend
iTrader: (46)
 
Joined: Jan 2007
Posts: 33,786
Likes: 455
From: San Antonio, Texas
Even driving normally you will have noticeable consumption.
Old 04-30-2014 | 05:44 PM
  #11  
dezau's Avatar
Thread Starter
Registered
iTrader: (3)
 
Joined: Mar 2009
Posts: 1,711
Likes: 2
From: Windermere, FL
I've tried looking, there's really not a noob guide to check the OMP lines, is this something the dealer can do but would **** me over? I really don't have the time to do it myself.
Old 04-30-2014 | 05:47 PM
  #12  
RIWWP's Avatar
Registered
iTrader: (2)
 
Joined: Oct 2007
Posts: 16,684
Likes: 261
From: Pacific Northwest
Google: site:rx8club.com clean omp line
Results: https://www.google.com/search?q=site...+line&safe=off

First 3 threads:
https://www.rx8club.com/series-i-tec...eaning-217177/
https://www.rx8club.com/series-i-do-...ectors-225253/
https://www.rx8club.com/series-i-tec...method-225321/


Gotta use Google
Old 04-30-2014 | 05:50 PM
  #13  
dezau's Avatar
Thread Starter
Registered
iTrader: (3)
 
Joined: Mar 2009
Posts: 1,711
Likes: 2
From: Windermere, FL
Thanks for the spoon. I did come up with those threads and read some of it but none of it makes sense to me lol

And another problem, the SSV was fucked a while ago and I paid like 5, 600 bucks for the dealer to fix it, then Cam at Pettit did something to that vacuum system when he was rebuilding the engine for me, not sure what, he said it was a fix for the vacuum system or whatever, is this related?

Last edited by dezau; 04-30-2014 at 05:55 PM.
Old 04-30-2014 | 05:54 PM
  #14  
RIWWP's Avatar
Registered
iTrader: (2)
 
Joined: Oct 2007
Posts: 16,684
Likes: 261
From: Pacific Northwest
No, it changes the oil venting lines, which can help keep the intake valving clean, doesn't have any impact on the OMP system.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
uZu
New Member Forum
13
12-30-2015 01:35 PM
Davey's RX-8
Series I Trouble Shooting
0
07-28-2015 01:13 PM
dbarber
Series I Trouble Shooting
14
07-25-2015 02:34 PM
RotaryRider
New Member Forum
11
07-20-2015 08:05 AM
vssystemluba
New Member Forum
3
07-19-2015 05:16 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 03:16 PM.