please help!
#1
Registered User
Thread Starter
Join Date: Jun 2010
Location: Ohio
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
please help!
ok so i just installed a sohn adapter and a bhr ignition yesterday and since then my car has stalled 3 time and has been hard to start any ideas? it also bogs down if i get over 6-7k rpms under load.
#6
Registered User
Thread Starter
Join Date: Jun 2010
Location: Ohio
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
im really really sure i got the spark plugs right i have put 3 sets in the car. also im a auto tech for acura mixing up the spark plugs is something i dont think is possible with them being labeled on the plug its self. :P
Last edited by Avox; 09-14-2011 at 08:43 PM.
#7
Registered User
since you fix hondas, then you probably did a mistake haha jk, other possibilities is the amount of torque you could have used, and like soldier said maybe the wires are mixed
#15
Registered User
Thread Starter
Join Date: Jun 2010
Location: Ohio
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
hmm so you found my thread charles lol, went for a quick drive since i filled up the tank with some premix in it and it doesnt seem to be bogging down anymore or having trouble starting... could it be the sohn adapter isnt feeding enough 2 stroke into the engine?
#19
Registered User
Thread Starter
Join Date: Jun 2010
Location: Ohio
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
hmm i dont remember giving you codes in the email. its not missfireing that we could tell with our new snap-on scan tool. i didnt remove any tubes when installing the sohn either, even though it was a pain in the *** o install.
#20
Registered User
Thread Starter
Join Date: Jun 2010
Location: Ohio
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
also in the instructions for the sohn the last thing was an oil flow test but i could find it anywhere in my manual or online any ideas as to what it is? ill be heading to bed now and will check this in the morning.
#23
Registered User
Thread Starter
Join Date: Jun 2010
Location: Ohio
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
ok after driving it this morning and putting it threw its paces after being at operating temp it ran completely fine since i put the premix in the tank, im rather sure that the sohn adapter isnt giving the engine enough 2 stroke any way to fix this? aside frome using the omp mod or adjuster.
Last edited by Avox; 09-15-2011 at 09:24 AM.
#24
Registered User
Thread Starter
Join Date: Jun 2010
Location: Ohio
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
ok whew thought i was going crazy last night lol but yea i installed the tank for it right next to the windshield washer fluid tank and the lines are not kinked in any way i can see 2 stroke in the lines coming from the omp to the injectors, but its only in small amounts with what looks like air between the oil and not every line has the 2 stroke in it........