SCREEEEECH at a cold start?
#1
SCREEEEECH at a cold start?
2006
76K
Runs perfect
Original clutch
Cold start...no noise...warm the thing up...all is well and like new when you take off.
Cold start...put it in gear but leave clutch in...don't move...wam things up...all is well............
COLD START...PUT IT IN GEAR...LET OUT CLUTCH SO YOU CAN MOVE...SCREEEEECH....LOUD....GOES FOR 15 SECONDS.....SCREECH/SQUEEEEEEELLLL!!!! Won't do it again until the next day.
OK...throwout bearing on the way out? Other? Thanks!
76K
Runs perfect
Original clutch
Cold start...no noise...warm the thing up...all is well and like new when you take off.
Cold start...put it in gear but leave clutch in...don't move...wam things up...all is well............
COLD START...PUT IT IN GEAR...LET OUT CLUTCH SO YOU CAN MOVE...SCREEEEECH....LOUD....GOES FOR 15 SECONDS.....SCREECH/SQUEEEEEEELLLL!!!! Won't do it again until the next day.
OK...throwout bearing on the way out? Other? Thanks!
#3
Hmmm, it's not the belt. We'll have to find the pump locale and see where it squeals with the hood open. I just can't see why the pump would only squeel when I let out the clutch and start moving.
#4
I read above but...honestly, it sounds like a belt. Tighten the tensioner a bit and see what happens.
It will only squeal when you start driving because there is load on the engine and it changes the forces on the belt...
It will only squeal when you start driving because there is load on the engine and it changes the forces on the belt...
Thread
Thread Starter
Forum
Replies
Last Post
IamFodi
Series II Interior, Audio, and Electronics
28
10-31-2018 07:37 AM
dbarber
Series I Trouble Shooting
14
07-25-2015 02:34 PM