Series 2 Taillights fit on a Series 1?
#1
Registered User
Thread Starter
Join Date: Aug 2010
Location: Manvel, Tx
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
Series 2 Taillights fit on a Series 1?
Like the title said I was curious if the Series 2 tail lights will fit onto the Series 1 I really do like those better then the stock series 1 and so I was just curious in case I found a junked series 2 with good tail lights.
Thanks,
Thanks,
#3
2009 RX-8 Touring
Even if they did, the brake lights are LEDs and their power requirements are different. It's entirely possible you'd burn out the brake light switch if you swapped them in, without adding the necessary resistors to the circuit.
#5
Registered User
Thread Starter
Join Date: Aug 2010
Location: Manvel, Tx
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
Damn... oh well...
Adding the resistors wouldn't be to hard lol least I hope not I mean I did go to school for it.
But that is something I had not yet gotten to considering since I didn't even know if the lights would fit :/ so thanks for the heads up though.
Adding the resistors wouldn't be to hard lol least I hope not I mean I did go to school for it.
But that is something I had not yet gotten to considering since I didn't even know if the lights would fit :/ so thanks for the heads up though.
#6
Registered User
Thread Starter
Join Date: Aug 2010
Location: Manvel, Tx
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
#9
Guest
Posts: n/a
Resistors would INCREASE the current draw. This is the only way you would "burn out the brake light switch" if you had TOO much resistance in the circuit.
LED's consume less power than conventional bulbs. This means less resistance and less current draw.
The reason you need to add a resistor when swapping out the turn signals on a car is to pull enough current to activate the flasher module.
Not to say swapping to LED wouldn't cause problems but it won't burn out the brake switch...
#11
Registered
iTrader: (2)
Join Date: Oct 2007
Location: Pacific Northwest
Posts: 16,684
Likes: 0
Received 253 Likes
on
110 Posts
His unauthorized group buy was shut down and he was warned, this is an attempt to circumvent the rules regarding that. He has received a 2nd warning and all of the posts have been deleted. If you see him try again report it so we can permaban him.
#12
Registered
Thank you to RIWWP for the discussion and guidance. As per discussion, I'm not being ignorant...just didn't really understand the rules on the forum.
Will be posting my review of a set of Series 2 Tail Light that I saw installed in a Series 1 after consulting with RIWWP.
Will be posting my review of a set of Series 2 Tail Light that I saw installed in a Series 1 after consulting with RIWWP.
#13
Registered
Like most of you, I surf this forum frequently looking for products, info and the next thing cool to do to my car.
I wanted to share that I have found a Series 2 Tail Light Kit which retrofits in Series 1 in North America.
Saw these tail lights in person.
- No need to get a series 2 bumper, direct replacement
- Great fit, gaps in even with no bulging at the quarter panel and rear bumper
- LED harness included, directly plug into the existing OEM wiring
- Comes with a new tail light gasket to eliminate condensation into the light assemble
Here is pictures of them from the owner's car.
![Name: S2toS1TailLightConversionKit01.jpg
Views: 3311
Size: 49.2 KB](https://www.rx8club.com/attachments/series-i-tech-garage-22/220068d1501206965-series-2-taillights-fit-series-1-s2tos1taillightconversionkit01.jpg)
![Name: S2toS1TailLightConversionKit02.jpg
Views: 1723
Size: 47.8 KB](https://www.rx8club.com/attachments/series-i-tech-garage-22/220069d1501206965-series-2-taillights-fit-series-1-s2tos1taillightconversionkit02.jpg)
PM me if you have any questions and want more info.
Thank you for the advise of RIWWP and the moderators on this forum.
I wanted to share that I have found a Series 2 Tail Light Kit which retrofits in Series 1 in North America.
Saw these tail lights in person.
- No need to get a series 2 bumper, direct replacement
- Great fit, gaps in even with no bulging at the quarter panel and rear bumper
- LED harness included, directly plug into the existing OEM wiring
- Comes with a new tail light gasket to eliminate condensation into the light assemble
Here is pictures of them from the owner's car.
![Name: S2toS1TailLightConversionKit01.jpg
Views: 3311
Size: 49.2 KB](https://www.rx8club.com/attachments/series-i-tech-garage-22/220068d1501206965-series-2-taillights-fit-series-1-s2tos1taillightconversionkit01.jpg)
![Name: S2toS1TailLightConversionKit02.jpg
Views: 1723
Size: 47.8 KB](https://www.rx8club.com/attachments/series-i-tech-garage-22/220069d1501206965-series-2-taillights-fit-series-1-s2tos1taillightconversionkit02.jpg)
PM me if you have any questions and want more info.
Thank you for the advise of RIWWP and the moderators on this forum.
Last edited by 2hit6; 02-02-2015 at 01:51 PM.
#15
Registered
iTrader: (2)
Join Date: Oct 2007
Location: Pacific Northwest
Posts: 16,684
Likes: 0
Received 253 Likes
on
110 Posts
He can't post the link right now due to the vendor advertising rules that nearly got him banned. You will need to use PM to avoid that reoccuring at the moment.
I'm satisfied he isn't a vendor trying to sell them, but I'd rather not recommend he does something that another staff member could see and boot him for without getting the updated information.
I'm satisfied he isn't a vendor trying to sell them, but I'd rather not recommend he does something that another staff member could see and boot him for without getting the updated information.
#16
Administrator
iTrader: (7)
Brettus: make sure to share that info with me once you get the PM.
kthanxbai.
kthanxbai.
#19
Registered
Difference in opinion. Not sure if they're from the same seller.
But the set that I saw looked pretty good and shipped from Japan. Will see the owner in the spring so could do a updated picture post.
Considering many of the OEM tail lights are made in Taiwan these days and cost to replace an OEM set due to condensation or water in the assemble.
These may be an alternative. Will getting this off eBAY charge you a custom tax/fee?
But the set that I saw looked pretty good and shipped from Japan. Will see the owner in the spring so could do a updated picture post.
Considering many of the OEM tail lights are made in Taiwan these days and cost to replace an OEM set due to condensation or water in the assemble.
These may be an alternative. Will getting this off eBAY charge you a custom tax/fee?
#20
Super Moderator
These are not OEM S2 Tail Lights but knock offs modified to fit Series 1 light housing.
#22
SARX Legend
iTrader: (46)
![TX](https://www.rx8club.com/images/icons/tx.jpg)
Difference in opinion. Not sure if they're from the same seller.
But the set that I saw looked pretty good and shipped from Japan. Will see the owner in the spring so could do a updated picture post.
Considering many of the OEM tail lights are made in Taiwan these days and cost to replace an OEM set due to condensation or water in the assemble.
These may be an alternative. Will getting this off eBAY charge you a custom tax/fee?
But the set that I saw looked pretty good and shipped from Japan. Will see the owner in the spring so could do a updated picture post.
Considering many of the OEM tail lights are made in Taiwan these days and cost to replace an OEM set due to condensation or water in the assemble.
These may be an alternative. Will getting this off eBAY charge you a custom tax/fee?
There are plenty of high quality pics of these and they are made in Thailand.
Not high quality but good enough to see how Alteezaish they are.
![](https://farm9.staticflickr.com/8639/16404507566_9703d5035d_b.jpg)
![](https://farm8.staticflickr.com/7324/16430482735_bf908d1067_b.jpg)
Last edited by 9krpmrx8; 02-02-2015 at 03:37 PM.
#25
Registered
Just check with the owner and his set of lights are made in Taiwan. Can't really measure the quality, not like I have meter to measure the thickness. I guess only time will tell if they last in hot summer and cold winters. Not here to argue right or wrong...just sharing info. Take it with a grind of salt. As for those who goes the eBay route...watch out for the tax at customs EMS shipping will slam on the product. Good luck. At least there is now a product for those who don't have the time to mess around with full OEM series 2 conversions.
I wonder where OEM Series 2 tail lights are made?
OEM Series 2 lights.
![](http://images.thecarconnection.com/lrg/2010-mazda-rx-8-4-door-coupe-man-grand-touring-tail-light_100237556_l.jpg)
OEM Spirit R Series 2 lights.
S2 Style Tail Light Retrofit I've seen in person.
I wonder where OEM Series 2 tail lights are made?
OEM Series 2 lights.
![](http://images.thecarconnection.com/lrg/2010-mazda-rx-8-4-door-coupe-man-grand-touring-tail-light_100237556_l.jpg)
OEM Spirit R Series 2 lights.
![](http://x-ultimate.bosmobil.com/uploads/news/0.content/image/modifikasi/Mazda_RX-8_Modifikasi_Tomi_Airbrush/Mazda_RX-8_Modifikasi_05.jpg)
S2 Style Tail Light Retrofit I've seen in person.
![](http://i287.photobucket.com/albums/ll129/eggtart23/S2toS1TailLightConversionKit02.jpg)