I'll be performing an engine swap within the next few weeks and would like to know what special tools I'll need to make sure the swap goes easy/smooth.

I've done 3/4 engine swaps in the past w/ my old Mx6 with a standing engine hoist and stand along w/ you basic rachet set and extensions.

Thanks in advance

 

You might like this thread.
https://www.rx8club.com/rx-8-multimedia-photo-gallery-6/charles-hill-engine-rebuild-51k-turbocharged-rx-8-a-148395/

 

thnx .... just watched the youtube version

 

^ listen to the master!!!

 

if you are going to be changing the pilot bearing---have a really good puller---the autozone kind will not do it!
You will need a 3/4 pull handle and a big *** socket to get the flywheel off. I forget the size.
Olddragger