Notices
Series I Tech Garage The place to discuss anything technical about the RX-8 that doesn't fit into any of the categories below.

transmission/clutch

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 10-27-2013, 11:11 PM
  #26  
Driving my unreliable rx8
 
logalinipoo's Avatar
 
Join Date: Oct 2012
Location: Alvarado, Tx
Posts: 2,051
Received 7 Likes on 7 Posts
Originally Posted by logalinipoo
I don't think it is the clutch cylinder. The spring on the pedal is what make s it pop back up. Try to get under the dash and work the pedal by hand looking for that bracket to move.

Well good thing you got that one fixed.

Did you replace both of the rear springs? or just the one?
Old 10-28-2013, 12:04 AM
  #27  
Yank My Wankel
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
Originally Posted by freewayracing
well this issue has been fixed and so has a few others now im stuck on the rear suspension the rear driver side is sagging 1/2in so i bought new springs and its still sagging i feel everything on the rear driver side i was wondering if even though the springs control ride height if the rear shocks were to blame also the spring on the rear driver is loose as in i can jiggle it but the passenger isnt
Maybe over looked, but are you sure you are parked on a flat surface. I noticed the same thing when my car is in the garage. Pull it into the driveway and both sides are the same.
Old 10-28-2013, 03:05 AM
  #28  
Registered
Thread Starter
 
freewayracing's Avatar
 
Join Date: Mar 2013
Location: Niagara Falls, N.Y
Posts: 27
Likes: 0
Received 0 Likes on 0 Posts
actually replaced all four got them in a set not to sure if all surfaces were flat but still dont account for y i feel everything also on that side
Old 10-28-2013, 12:26 PM
  #29  
Driving my unreliable rx8
 
logalinipoo's Avatar
 
Join Date: Oct 2012
Location: Alvarado, Tx
Posts: 2,051
Received 7 Likes on 7 Posts
I was thinking if you had done just the one it would might have been togther wrong to start, but if you did both sides then you should have noticed any differances in the bushings. I know when I did my shocks I had a bushing in there wrong and it gave a heck of a thump on every bump.
Old 10-29-2013, 04:27 AM
  #30  
Registered
Thread Starter
 
freewayracing's Avatar
 
Join Date: Mar 2013
Location: Niagara Falls, N.Y
Posts: 27
Likes: 0
Received 0 Likes on 0 Posts
The stopper bump is worn out on both side but one side more than the other
Old 10-29-2013, 08:38 AM
  #31  
Registered
iTrader: (25)
 
TeamRX8's Avatar
 
Join Date: Apr 2005
Posts: 26,862
Likes: 0
Received 2,080 Likes on 1,694 Posts
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Devil Doge
Series I Tech Garage
0
04-11-2015 05:02 PM
Munchy
Series I Tech Garage
7
06-30-2013 09:01 PM
RX8inSTL
Series I Trouble Shooting
1
07-06-2012 03:37 PM
elusiv
RX-8 Discussion
9
01-13-2005 11:11 AM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.

Quick Reply: transmission/clutch



All times are GMT -5. The time now is 05:43 AM.