AT Brake pedal and MT Brake Pedal compatability
#1
AT Brake pedal and MT Brake Pedal compatability
Ok i need to know if the MT brake pedal works direct bolt on with a AT setup without problems. Im aware the unit splits into two halves and the MT pedal will pug into the upper half of the AT's bracket, but i wanted to be sure the MT pedal will work on a AT setup. Thanks
#3
Rotary Stall Out
Join Date: Oct 2006
Location: Delaware
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
I can't find the thread, but there is a serious one one on a full swap from automatic to manual, engine swap and all- it's been done in the "how to" section. It would take a lot of work just to have a smaller pedal. I thought about doing the complete swap, so this was on the parts list.
found it https://www.rx8club.com/showthread.p...highlight=swap
found it https://www.rx8club.com/showthread.p...highlight=swap
Last edited by gothmogthebalrog; 03-01-2012 at 12:29 AM.
#4
I can't find the thread, but there is a serious one one on a full swap from automatic to manual, engine swap and all- it's been done in the "how to" section. It would take a lot of work just to have a smaller pedal. I thought about doing the complete swap, so this was on the parts list.
found it https://www.rx8club.com/showthread.p...highlight=swap
found it https://www.rx8club.com/showthread.p...highlight=swap
And ive already put the brake pedal in at this point... a little tricky but wasnt too hard. I found installing brake rotors more difficult
Thread
Thread Starter
Forum
Replies
Last Post