Clutch Master Cylinder stuck, engine out
#1
Bat Mobile Driver
Thread Starter
Clutch Master Cylinder stuck, engine out
Hey there all I'm having problems with my clutch pedal going to the floor as well... Long story shourt I removed my engine and while the engine was out I mistakingly hit the clutch pedal and it went to the floor. The mastercylinder is fully extended and it seems to be stuck open... I need some advice. I tried bleeding, I don't know what else I can do to get it back to normal.... Thanks
#5
Bat Mobile Driver
Thread Starter
#6
Bat Mobile Driver
Thread Starter
#8
Bat Mobile Driver
Thread Starter
^ I gave that a try last night it was still hard and didn't move. So how much pressure should I be putting on it?? I'm thinking not much but I put a little muscle into it too and nothin.
#11
Bat Mobile Driver
Thread Starter
#13
Yank My Wankel
iTrader: (4)
FYI, im still dealing with bleeding my clutch after I changed out the lines last week, im picking up a vacuum bleeder later today and giving it another go. its that much of a PITA traditional bleeding does almost nothing when the system is completely dry as the CMC does not push nearly as much fluid as the BMC people have had experiences of even after an hour of traditional bleeding minimal progress was made. Basically I would exhaust all routes before taking it apart.
#15
Bat Mobile Driver
Thread Starter
Haha.. in my case I put motor in for a compression test and clutch went poop to the floor I was like WTF hahaha. What did u use to compress it??
#18
Bat Mobile Driver
Thread Starter
FYI, im still dealing with bleeding my clutch after I changed out the lines last week, im picking up a vacuum bleeder later today and giving it another go. its that much of a PITA traditional bleeding does almost nothing when the system is completely dry as the CMC does not push nearly as much fluid as the BMC people have had experiences of even after an hour of traditional bleeding minimal progress was made. Basically I would exhaust all routes before taking it apart.
#19
Boosted Kiwi
iTrader: (2)
Also : bleeding was not that difficult . I just pumped the pedal a few times , open the bleeder with pedal down . Pull pedal up . Do that a few times . Then have someone push pedal down while bleed screw is open then close screw and pull pedal up and repeat a couple of times .
#20
Bat Mobile Driver
Thread Starter
O ok I beleave the pedal isn't coming back has something to do with the slave cylinder not compressing back to its normal position so there's probly no fluid in the clutch master.
#21
Bat Mobile Driver
Thread Starter
Also : bleeding was not that difficult . I just pumped the pedal a few times , open the bleeder with pedal down . Pull pedal up . Do that a few times . Then have someone push pedal down while bleed screw is open then close screw and pull pedal up and repeat a couple of times .
#24
Bat Mobile Driver
Thread Starter