Notices
Series I Trouble Shooting This is the place to learn more about or discuss any issues you're having with your RX-8

Engine trouble

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 03-11-2011 | 11:24 AM
  #1  
cripy's Avatar
Thread Starter
Registered User
 
Joined: Mar 2011
Posts: 2
Likes: 0
Engine trouble

trouble with 04 RX8 ST had the motor replaced twice, replace plugs and wires recently, ran seafoam through the car disconnected the CAT from the car. flushed the coolent system. Still having issues the car is about a ten mile car It runs perfect until the car warms up. Once it is warm the coolent light will come on and a few miles later the car will start to cut out. If you need to stop in traffic the car will die or get sluggish and lose power. Cut the car off and let set it will run good again for awhile Just wondering what to try next if anyone could help.
Old 03-11-2011 | 11:58 AM
  #2  
DeViLbOi's Avatar
The devil made me do it
iTrader: (1)
 
Joined: Jul 2007
Posts: 3,708
Likes: 2
From: Colorado Springs, CO
Checked your thermostat?
When you say you "disconnected the CAT from the car", what did you replace it with?
Any CEL codes?
Old 03-11-2011 | 02:50 PM
  #3  
cripy's Avatar
Thread Starter
Registered User
 
Joined: Mar 2011
Posts: 2
Likes: 0
Just disconected the CAT and drove it still had the same result just was a little louder well alot louder
Old 03-11-2011 | 06:27 PM
  #4  
DeViLbOi's Avatar
The devil made me do it
iTrader: (1)
 
Joined: Jul 2007
Posts: 3,708
Likes: 2
From: Colorado Springs, CO
a lot louder...probably a lot warmer as you shot flames all over the bottom of your car and probably started melting some things. Im sure your drive shaft wasn't too happy about that idea either. Now you should have a bunch of codes to read.
Old 03-11-2011 | 10:24 PM
  #5  
DocBeech's Avatar
I drive at Red Line.
iTrader: (1)
 
Joined: Jul 2010
Posts: 2,137
Likes: 5
From: Dallas, TX
You should never run open headers unless you have a way to send the exhaust out the side of the car. Did you put up a heat shield? Did you melt the wiring harness for the o2 sensors?
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ladnarf1
New Member Forum
4
04-30-2021 12:53 AM
vapor2
West For Sale/Wanted
11
11-03-2020 04:38 PM
GracefulShanks
New Member Forum
9
08-18-2015 12:40 PM
rx8wankelrotary
New Member Forum
9
08-17-2015 11:42 AM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 07:21 PM.