Help car spurdding and cel blinking
#1
suck my smog
Thread Starter
Join Date: Jun 2008
Location: Windsor, Califorina
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Help car spurdding and cel blinking
I've been noticing that my car is sputtering when accerating, I hit redline looked down and my CEL was blinking wtf! Please help me I have new coils(oem), ngk spark plugs, and maztrix 10mm wires all were replaced as of augest any help well be great! O I have a 2004 mt
#2
75shot55fueljets=GOBABYGO
Join Date: Dec 2007
Location: Sebastopol, CA
Posts: 142
Likes: 0
Received 0 Likes
on
0 Posts
Sounds too rich. hard to say but thats my 10 cents.
P0172 System too rich
also do a check on your nitrous switch make sure its off. maybe you were spraying by mistake?
P0172 System too rich
also do a check on your nitrous switch make sure its off. maybe you were spraying by mistake?
Last edited by SebtownRx8; 12-13-2008 at 10:15 PM.
#3
Grasshopper
iTrader: (1)
I've been noticing that my car is sputtering when accerating, I hit redline looked down and my CEL was blinking wtf! Please help me I have new coils(oem), ngk spark plugs, and maztrix 10mm wires all were replaced as of augest any help well be great! O I have a 2004 mt
It'll be easier to diagnose, or else we're just guessing.
#5
suck my smog
Thread Starter
Join Date: Jun 2008
Location: Windsor, Califorina
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
#6
suck my smog
Thread Starter
Join Date: Jun 2008
Location: Windsor, Califorina
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
#7
Grasshopper
iTrader: (1)
For our car your reader needs to be able to read the CAN-bus protocol.
Just take it to Autozone and get it read for free (I have yet to find an Autozone that couldn't read it, but I'm sure some locations still use an older scanner).
If you're cleaning the intake, spray the MAF sensor with MAF cleaner or an electrical contact cleaner.
Take a peak around the accordion tube and throttle body and see if there is oil around that area.
Just take it to Autozone and get it read for free (I have yet to find an Autozone that couldn't read it, but I'm sure some locations still use an older scanner).
If you're cleaning the intake, spray the MAF sensor with MAF cleaner or an electrical contact cleaner.
Take a peak around the accordion tube and throttle body and see if there is oil around that area.
#8
suck my smog
Thread Starter
Join Date: Jun 2008
Location: Windsor, Califorina
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
I went to autozone and they said that they could not read codes anymore because of some lawsuit or something like that they said that aamco transmission can read it for free so I'm going to go there on my lunch tomorrow I will let you guys know what the cel is when I find out
Thread
Thread Starter
Forum
Replies
Last Post
dbarber
Series I Trouble Shooting
14
07-25-2015 01:34 PM