How to start your car when it wont start
#31
car won't start
I bought an RX8 for my son, and it wouldn't start once we got it home... crank censor light was on, and we replaced it...still won't start... diagnostic showed problem U0073 control monitor and U0101 lost communication with TCM (i think transmission contro module)... if anyone is familiar with these issues... please help... thanks...
#32
Please search on the forums for your codes and read through the threads. sorry to hear about yrou sons car.
free help, in the link below. Start there and use the search button
http://www.revolutionrotorclub.com/f...ne_Control.pdf
free help, in the link below. Start there and use the search button
http://www.revolutionrotorclub.com/f...ne_Control.pdf
#33
Administrator
jhandlsu
1What light was on and what did you replace?
2. the U codes are usually communication errors caused by incompatible scanners
later im going to take this out of this thread and put it in your own trouble shooting thread. it will just get lost here
1What light was on and what did you replace?
2. the U codes are usually communication errors caused by incompatible scanners
later im going to take this out of this thread and put it in your own trouble shooting thread. it will just get lost here
#34
RX8 Won't Start
Just bought on '05 Automatic with 43000 miles on internet auction. Vehicle was delivered yesterday...Battery dead. Tried jumping, will turn over but not start. I know little about rotaries, but am mechanically inclined. Is there something obvious I am missing? How do I check for fuel delivery and fire? No codes are stored. Where to start?
#36
Help me
just got a 192ps had new radiator fitted,everthing fine and car running well. Didnt use car for a couple of days due to bad snow so i thought i would start up to let it run for five minutes,it ran for five minutes then cut out.struggled to start it again and when it started the engine warning light started flashing and then stayed on after a minute or so the revs start dropping then it cuts off again. last night it did it again and now it wont start at all. Please help me.
#37
i have a hill outside my door--roll it out down the hill- get it up to speed and put it in third with pedal to the floor--fires right up-blows out white smoke and runs like a charm--flooding over
#39
instead of being smartasses try and be helpful , dont just tell people to search tell them what to search for.. I've searched flooding , and got million threads , I searched car wont start , and get this useless pile of words .
if someone is in a jam and their car wont start you think they want to read this useless thread that gives absolutely no help to anyone?
yeah search is a good idea but when someone doesn't know what keywords trigger the answer they are after its just frustrating . look at it from the person who is going through the trouble's point of view not your lazy I dont want to read more car wont start thread point of view.
if someone is in a jam and their car wont start you think they want to read this useless thread that gives absolutely no help to anyone?
yeah search is a good idea but when someone doesn't know what keywords trigger the answer they are after its just frustrating . look at it from the person who is going through the trouble's point of view not your lazy I dont want to read more car wont start thread point of view.
#40
Thanks for the feedback... when I created this thread there was about 10 different threads created by people to lazy to search through the many different threads out there.
Also I'm sure this wasn't the only thread that came up when you searched, this might have been the first one but it certainly wasn't the only one.
The fact of the matter is the renesis engine and most rotary engines are far more complex than most people imagine. so there is no simple answer on how to start your car, when it wont start.
My advice would be to search more, lighten up, and start reading.
Most of us who have been on here for a while have the factory service manual and have been using that to troubleshoot issues. I guarantee you there is a thread that has been started over the past 7 years describing whatever issue you are having with your car.
Also I'm sure this wasn't the only thread that came up when you searched, this might have been the first one but it certainly wasn't the only one.
The fact of the matter is the renesis engine and most rotary engines are far more complex than most people imagine. so there is no simple answer on how to start your car, when it wont start.
My advice would be to search more, lighten up, and start reading.
Most of us who have been on here for a while have the factory service manual and have been using that to troubleshoot issues. I guarantee you there is a thread that has been started over the past 7 years describing whatever issue you are having with your car.
#43
The Angry Wheelchair
iTrader: (14)
This came to mind..
Wayne Campbell: All I have to say about that is "asphinctersayswhat".
Noah Vanderhoff: What?
Wayne Campbell: Exactly.
#48
Registered User
iTrader: (1)
Join Date: Jan 2011
Location: Indianapolis
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
I get this, I find it funny. But sticking this when there should be a stick that actually has answers in it would be more useful for everyone. (including people tired of hearing about it)
I came to this forum section first to see if there was a sticky on this problem or at least a thread with recent updates first because "car won't start" isn't a great search. I saw this and got pumped. only to have a chuckle then get pissy about it and post a whinny response...
ON TO SEARCHING!!!!!
I came to this forum section first to see if there was a sticky on this problem or at least a thread with recent updates first because "car won't start" isn't a great search. I saw this and got pumped. only to have a chuckle then get pissy about it and post a whinny response...
ON TO SEARCHING!!!!!
#49
Registered User
iTrader: (1)
Join Date: Jan 2011
Location: Indianapolis
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Wow the search button works! /sarcasm
I found a good how to in the DIY section.https://www.rx8club.com/series-i-do-yourself-forum-73/diy-deflooding-average-joe-plumber-182410/
DONE!
I found a good how to in the DIY section.https://www.rx8club.com/series-i-do-yourself-forum-73/diy-deflooding-average-joe-plumber-182410/
DONE!