Notices
Series I Trouble Shooting This is the place to learn more about or discuss any issues you're having with your RX-8

No heat in winter, no can't stop the heat in summer

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 07-03-2017 | 02:49 PM
  #1  
atikovi's Avatar
Thread Starter
Registered
 
Joined: Jun 2011
Posts: 24
Likes: 0
No heat in winter, no can't stop the heat in summer

Even with the temp **** at the coldest, the vents just blow heated air out. All I can do is put it in recirc mode so at least outside air isn't forced through the heater core but it's still very hot inside. Is this related to the heater control unit? I did the diagnostic and the **** goes from 0 to 16 no problem.
Old 02-18-2019 | 09:31 PM
  #2  
Alex Villeda's Avatar
New Member
 
Joined: Nov 2018
Posts: 1
Likes: 0
Same problem

I’m having the same problem, I went to doswell this past Christmas with my fiancée and my daughter to see the light show and on the way home the heat just stopped working. I don’t have any heat at all unless it’s warm outside. I tried flushing the heater core there was a piece of trash in it that looked like a piece of bubble gum and it kind of helped. if the cars been running for a while it’ll blow semi warm for a few seconds then blows cold again and I have to turn the air off and wait a little while for it to blow warm again. Did you figure out/ solve the issue?
Old 02-18-2019 | 09:34 PM
  #3  
atikovi's Avatar
Thread Starter
Registered
 
Joined: Jun 2011
Posts: 24
Likes: 0
Sold it before finding the problem.
Old 03-24-2019 | 05:37 PM
  #4  
Brian Walls's Avatar
New Member
 
Joined: Mar 2019
Posts: 1
Likes: 0
I just bought my RX-8 had 3 RX-7's but this my first 8. Have simaliar issue, no heat at all. Not sure where to satrt looking. Also temp gauge running at under 25% of gauge total.
Old 04-02-2019 | 02:14 PM
  #5  
1300CC's Avatar
Registered
 
Joined: Mar 2019
Posts: 60
Likes: 5
From: Cary, NC
Ensure your cooling system is performing properly. Past that, the solder joints on the PCB for the HVAC controls are known to go bad. Mine stuck itself on heat, and wouldn't adjust no matter how much I turned the **** and wished otherwise. There's a guide on here somewhere that shows you how to self test the HVAC climate control setting. I cant remember the exact procedure to put it into test mode, but a quick search should yield it. Very simple, and easy to tell you if the HVAC is the culprit. If so, there is also a guide on here for redoing the joints. Easy fix.

Last edited by 1300CC; 04-02-2019 at 02:18 PM.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Skylerreniger
New Member Forum
15
10-24-2014 08:38 AM
Hesselrode
Series I Trouble Shooting
8
09-22-2011 02:10 PM
FungsterRacing
Series I Do It Yourself Forum
3
09-09-2011 05:41 PM
200.mph
Series I Trouble Shooting
7
01-01-2010 10:49 PM
Falken
Series I Tech Garage
3
05-04-2008 10:32 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 12:25 AM.