Starvsnr

I am going to start searching after I post this as I am panicking currently. While replacing my ignition coils I was securing the new set on when I sheared the threading off of the plate/tray that hold the ignition coil. The bolt I was putting back on was the original and was rusted so it wasn't going on smoothly.

Is the contact between the ignition coil and that plate imperative? Can I run with one just a little loose in the mean time?

Edit:
Searching would of been faster than typing this:

https://www.rx8club.com/series-i-tec...ptions-243789/