Series II ECU Tuning
#630
Registered
just got word .... should have some info on the hypertech situation that we had on my car over summer, RIP said few weeks and would have info ... keep your fingers crossed
![Smilie](https://www.rx8club.com/images/smilies/smile.gif)
#632
Don't give up on mazdaedit! I'm slowly dissecting the rom now!
#634
Epihan is sometimes slow to respond to emails, but he is a small operation. I know he was ill this week. Hang tight, I know he is working on it. In the mean time we here are playing with the tables
#643
Registered
iTrader: (2)
Join Date: Jan 2008
Location: Dallas, Tx
Posts: 174
Likes: 0
Received 0 Likes
on
0 Posts
Paimon, are you familiar enough with both to list any differences, pros/cons, ease of use for different levels of expertise? Does the versatuner also require dongle and if so, is it same as MazdaEdit?
#644
Registered
iTrader: (15)
same dongle can be used (OpenPort 2.0 from tactrix). There isn't too much more I can reveal about the software itself in regards to versatuner, but the user interface itself is (imo) miles ahead of mazdaedit. I just got some screenshots from the developer showing off the datalogging features and parameters of the VT and they look great.
I can confirm that data has been dumped from my S2 without any issue, found and defined almost all tables that one would need to properly tune the car, DTC masking is available, ignition timing/dwell settings have been defined, logging parameters have been defined, and more.
Here is a preview of what the logging screen looks like as far as parameter selection:
I can confirm that data has been dumped from my S2 without any issue, found and defined almost all tables that one would need to properly tune the car, DTC masking is available, ignition timing/dwell settings have been defined, logging parameters have been defined, and more.
Here is a preview of what the logging screen looks like as far as parameter selection:
![](https://www.rx8club.com/attachments/series-ii-engine-tuning-164/193639d1363106754-series-ii-ecu-tuning-rx8-logging.jpg)
#645
Registered
iTrader: (2)
Join Date: Jan 2008
Location: Dallas, Tx
Posts: 174
Likes: 0
Received 0 Likes
on
0 Posts
Dynotronics was able to dump my ecu with MazdaEdit as well without issue. Just need to figure out if either or both will flash without issue. We know the price for MazdaEdit. Without letting anything out, any word on price point for versatuner?
#649
Registered
iTrader: (2)
Join Date: Jan 2008
Location: Dallas, Tx
Posts: 174
Likes: 0
Received 0 Likes
on
0 Posts
That's one thing I'm hoping for carrmutt. Also being able to adjust other options like idle would be nice. Looking through the versatune they state can do launch control and no lift shifting as well as community based tuning.