{ FS } Multiple items for sale
#1
Multiple items for sale
Category: Drivetrain
Price: $280
Private or Vendor Listing: Private Listing
Part Fits (you may select multiples): Series I
Location (US State/Canada/Int): DE
Item Condition: Used
Uninstalled, no issues - ready to ship
Cobb, tailllight, gauges sold
MS Fog Brackets, Cat, Headlight, Dash Cover, S2 Fuel Pump still available
Last edited by stinksause; 06-28-2015 at 08:40 PM.
#3
Greddy Turbo Timer
Greddy turbo timer
Remote screen
I bought this a few years back but never got around to using - it looks like everything is there
45 shipped
ITEM SOLD - MODS FEEL FREE TO PURGE THREAD
Remote screen
I bought this a few years back but never got around to using - it looks like everything is there
45 shipped
ITEM SOLD - MODS FEEL FREE TO PURGE THREAD
Last edited by stinksause; 06-28-2015 at 06:26 PM.
#14
OEM Cat and RB triple Pod
OEM Cat has about 40k on it - no issues. $300 shipped ($1500 new)
Glowshift Gauges - water, oil temp and oil pressure.
Will get better pics of the rb pod.
1 LED is burned out on the water temp gauge (leftmost on pic) - works fine otherwise.
Comes with Banjo bolt to tap into oil system for pressure and drain plug adapter for oil temp from pan.
RB Coolant Temp sensor adapter, all necessary sensor and wiring.
BNIB oil pressure sender.
$200 Shipped.
I'll get better pics soon.
Glowshift Gauges - water, oil temp and oil pressure.
Will get better pics of the rb pod.
1 LED is burned out on the water temp gauge (leftmost on pic) - works fine otherwise.
Comes with Banjo bolt to tap into oil system for pressure and drain plug adapter for oil temp from pan.
RB Coolant Temp sensor adapter, all necessary sensor and wiring.
BNIB oil pressure sender.
$200 Shipped.
I'll get better pics soon.
Last edited by stinksause; 06-20-2015 at 01:27 PM.
#16
Auto to Manual Conversion
Testing Waters here....
Based on RR's thread:
https://www.rx8club.com/series-i-spe...t-swap-151684/
I can put together the following for a potential buyer
-6sp trans, no grinds or other issues
-MT starter
-ACT clutch and Pressure Plate
-6sp carbon driveshaft
-clutch slave cylinder, master cylinder, hard line and SS braided line
-shifter assembly, ****, boot, inner trim ring (goes inside the silver trim ring on your console, which will get reused from your automatic)
-clutch and brake pedal assemblies (be sure the clutch pedal comes with the rod that actuates the master cylinder, some people remove them). The pedals I found had the pretty aluminum pads, so I also bought the matching accelerator pedal and dead pedal that also did, but this is completely optional/cosmetic and doesn't have anything to do with the swap itself. From what I could tell the accelerator pedal was identical. Also hope that they leave the switches on the clutch pedal for the starter interlock and cruise switch.
-MT steering wheel (Red and Black Interior)
-MT gauge cluster
-MT PCM, flip keyes, immobilizer and locks
-MT ABS pump from the same car the PCM came from.
I'll do $800 plus shipping and handling
Based on RR's thread:
https://www.rx8club.com/series-i-spe...t-swap-151684/
I can put together the following for a potential buyer
-6sp trans, no grinds or other issues
-MT starter
-ACT clutch and Pressure Plate
-6sp carbon driveshaft
-clutch slave cylinder, master cylinder, hard line and SS braided line
-shifter assembly, ****, boot, inner trim ring (goes inside the silver trim ring on your console, which will get reused from your automatic)
-clutch and brake pedal assemblies (be sure the clutch pedal comes with the rod that actuates the master cylinder, some people remove them). The pedals I found had the pretty aluminum pads, so I also bought the matching accelerator pedal and dead pedal that also did, but this is completely optional/cosmetic and doesn't have anything to do with the swap itself. From what I could tell the accelerator pedal was identical. Also hope that they leave the switches on the clutch pedal for the starter interlock and cruise switch.
-MT steering wheel (Red and Black Interior)
-MT gauge cluster
-MT PCM, flip keyes, immobilizer and locks
-MT ABS pump from the same car the PCM came from.
I'll do $800 plus shipping and handling
Last edited by stinksause; 06-26-2015 at 01:39 AM.
#20
Super Moderator
OP, just to confirm are all these parts (etc) FS for/from the same vehicle?
Requirements to FS here have changed slightly (read announcement) and is not to be used as an auction house or for selling parts which you physically do not own.
And could you update your #1 post with more detail and keep all FS to one thread only.
No member is permitted to run a business here, and I am not suggesting you are, I just want you to clarify your position...Thanks.
BTW (IF) you have sold 'items', how about you purge, note, modify or delete post on what is sold?
Requirements to FS here have changed slightly (read announcement) and is not to be used as an auction house or for selling parts which you physically do not own.
And could you update your #1 post with more detail and keep all FS to one thread only.
No member is permitted to run a business here, and I am not suggesting you are, I just want you to clarify your position...Thanks.
BTW (IF) you have sold 'items', how about you purge, note, modify or delete post on what is sold?
#22
Super Moderator
Every morning like many I can have 20-40 emails and alerts (not all forum related).
I Read after I posted that my colleague had told you and directed you to the FS changes.
I live in the Southern hemisphere so at times it is difficult to sync everything.
I posted it here for others to read too (and you, again)...OK with you?
I will repeat, you can also delete 'the mess' in your own thread (delete your FIRST Post, and thread is gone) and please no more multiple threads in FS.
Thread
Thread Starter
Forum
Replies
Last Post
SBGarage
Vendor Classifieds
0
09-06-2015 03:30 PM
SBGarage
Sakebomb Garage
0
09-06-2015 03:29 PM