Sub standard Steel sold to Mazda and other carmakers.
#1
40th anniversary Edition
Thread Starter
Sub standard Kobe Steel sold to Mazda and other carmakers.
ttps://www.wheelsmag.com.au/news/1710/sub-standard-steel-claims-have-car-makers-scrambling-for-answers?utm_source=Sailthru&utm_medium=email&utm_c ampaign=2017_October_11_Wheels&utm_term=list_wheel s_newsletter
Last edited by gwilliams6; 10-19-2017 at 11:44 AM.
The following users liked this post:
gwilliams6 (10-19-2017)
#3
Registered
iTrader: (1)
Mazda specifically said they weren't affected. Only Toyota, Honda and Nissan. So somebody is spouting out wrong information here.
Source is CNN:
The Kobe Steel scandal: What we know so far - Oct. 16, 2017
Source is CNN:
The Kobe Steel scandal: What we know so far - Oct. 16, 2017
#4
40th anniversary Edition
Thread Starter
Hornbm, the article says Mazda hasn't found any substandard steel YET, but is still searching its inventory. So there may have been substandard steel supplied and used in the past ,but Mazda just hasn't found it yet. This has apparently been going on for years and covered up by Kobe, so who knows how many cars, aircraft etc. were affected.
The following users liked this post:
gwilliams6 (10-19-2017)
#6
40th anniversary Edition
Thread Starter
Yes you are right NotAPreppie. Cars are bad enough with substandard below-strength metal, but can you imagine flying in an aluminum aircraft with sub-strength metal. Boeing and others were possibly supplied with this sub-strength metal. Not good at all.
If any structural failures and/or accidents can be tied to this sub-strength Kobe metal, watch out for the lawsuits, fines and/or criminal charges.
If any structural failures and/or accidents can be tied to this sub-strength Kobe metal, watch out for the lawsuits, fines and/or criminal charges.
Last edited by gwilliams6; 10-19-2017 at 09:56 AM.
#8
Registered
iTrader: (1)
Hornbm, the article says Mazda hasn't found any substandard steel YET, but is still searching its inventory. So there may have been substandard steel supplied and used in the past ,but Mazda just hasn't found it yet. This has apparently been going on for years and covered up by Kobe, so who knows how many cars, aircraft etc. were affected.
#9
Dark Moderator
iTrader: (18)
Bullet trains were built with substandard Kobe Steel parts - Oct. 12, 2017
Several articles state Mazda confirmed they purchased sub-par materials.
Travis
Several articles state Mazda confirmed they purchased sub-par materials.
Travis
The following users liked this post:
gwilliams6 (10-19-2017)
The following users liked this post:
NotAPreppie (10-19-2017)
#11
I'm not sure the steel was "bad", but the inspectors just took shortcuts to certify.
Japanese steel never seemed to corrode like GM stuff.
I remember all these GM cars in the 70's, Vega especially, where you could put a finger through the cowling near windshield of a less than 2 year old car.
Japanese steel never seemed to corrode like GM stuff.
I remember all these GM cars in the 70's, Vega especially, where you could put a finger through the cowling near windshield of a less than 2 year old car.
#12
40th anniversary Edition
Thread Starter
Yes Williard you are correct. Hornbm I just saw two video reports from CNN that said Mazda has confirmed they received sub-standard Kobe metal.
Last edited by gwilliams6; 10-19-2017 at 11:49 AM.
#13
Administrator
iTrader: (7)
#14
What am I doing here?
Join Date: Mar 2006
Location: 2017 Miata RF Launch Edition
Posts: 3,606
Received 649 Likes
on
510 Posts
Have they actually determined that the materials Mazda purchased were sub-standard or are they just assuming that because the testing was flawed?
Strictly speaking, the materials could still be acceptable even if the testing wasn't.
Strictly speaking, the materials could still be acceptable even if the testing wasn't.
#15
You gonna eat that?
iTrader: (1)
The following users liked this post:
Jedi54 (10-19-2017)
#16
///// Upscale Zoom-Zoom
#17
Dark Moderator
iTrader: (18)
![Smilie](https://www.rx8club.com/images/smilies/smile.gif)
I don't watch CNN either I was simply looking for articles that Mazda confirmed they purchased said materials.
Still begs the question, what does that equate to for owners?
Travis
The following users liked this post:
Jedi54 (10-19-2017)
#20
40th anniversary Edition
Thread Starter
I guess for us we care most about our RX8s, but maybe those of us who have also bought MX5s, 6s , 3s and CXs are also concerned. We will all just have to watch this story and see if it leads to any definitive evidence on any particular car models.
Last edited by gwilliams6; 10-20-2017 at 05:40 AM.