{ FS } Greddy Turbo Kit 20g
#1
Registered
Thread Starter
iTrader: (1)
Join Date: Nov 2008
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
Greddy Turbo Kit 20g
Category: Engine - Power Adders
Price: $2400
Private or Vendor Listing: Private Listing
Part Fits (you may select multiples): Series I
Location (US State/Canada/Int): IA
Item Condition: Used
It is still installed in the car as of right now, will be pulling it out as soon as it's sold, or if I can get access to a garage to start tearing the car down sooner.
UPDATE: Kit is out and ready to ship. I can send pics upon request.
I bought the kit off of another member, and I only put roughly 1500 miles on it.
All turbo piping/couplers/clamps/turbo/manifold/downpipe/oil line/drain pan adaptor/and a sandwich plate for the oil feed line. I do not have the E manage. I used the Cobb to run the turbo.
It is a Full Greddy Kit. Had the 18g turbo housing with a 20g CHRA. Godspeed intercooler, not sure of dimensions, but I know it fits and I will include my brackets w that I made for it. Also has Tial Q BOV, and Turbosmart Manual boost controller. Has a BHR intake tray. And I will include the boost gauge that I have for it.
I loved this kit for the short time that I had it. Never did get fully tuned, which is why motor blew (my fault). But on partial tune, it still sucked you into the seat.
Asking 2400. If you have any questions feel free to ask. thanks, Sean.
Intercooler pic.
Last edited by SEANMAC777; 10-04-2011 at 12:37 AM. Reason: better description
#9
Was probably due to charge air temperature.
Last edited by Frosty288; 09-10-2011 at 11:19 PM.
#20
Registered
Thread Starter
iTrader: (1)
Join Date: Nov 2008
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
Yes, Chicago is only 4 hours from me. All parts are included. It will be ready to go, however you might want to buy a new gasket for the oil sandwich plate. (5.00 shipped).
Very easy, in my opinion. I had never seen a turbo before I bought this kit, and I installed it in just a couple evenings.
I also took the Greddy instructions, laminated them,and put them in a binder for a guide while I did the build. I will include this too.
Very easy, in my opinion. I had never seen a turbo before I bought this kit, and I installed it in just a couple evenings.
I also took the Greddy instructions, laminated them,and put them in a binder for a guide while I did the build. I will include this too.