{ FS } Complete RX-8 Race Ready Drive train EP, STU, STL
#1
Complete RX-8 Race Ready Drive train EP, STU, STL
Category: Drivetrain
Price: $12000
Private or Vendor Listing: Private Listing
Part Fits (you may select multiples): Others, Series I, Series II
Location (US State/Canada/Int): KS
Item Condition: Used
- Luis Rivera built motor with ceramic apex seals, 5 hours on motor since refreshed by Kan Tuning.
- Motec M-800 ECU. Tuned for existing motor.
- Motec ADL Dash.
- Wire harness for MoTeC, and ADL dash
- Racing Beat intake.
- New (one dyno run) Mazda Series II, 6-speed transmission with new shifter & throw out bearing
- One race weekend on 5.11 differential with OE limited slip (REM treated) set up by Jesse Prather Motorsports
- Tilton 5.5” clutch, with new, disks, floater and pressure plate.
- New lightweight aluminum racing flywheel.
- Black Halo Racing coils.
- Racing Exhaust (header, mid pipe, muffler)
- Drive shaft
I'd like to sell as a complete package but will part out if there are no takers.
Feel free to call.
Thanks,
Steve Smyczek
414-339-5084
#6
Hard to see the REM treated 5.11 ratio
5 hrs on rebuild
Rebuilt Trans, new clutch, flywheel
MoTeC M 800 already tuned for engine, complete wire harness in box
MoTec ADL Dash 3.20d is the software rev. . I bought a Motec GPS setup but never used it, you get that too.
Exhaust including header
Racing Beat Intake
Thread
Thread Starter
Forum
Replies
Last Post
thirdgenrx7r1
RX-8's For Sale/Wanted
10
03-19-2010 04:52 PM