Width advice
#1
Width advice
So in a few months im pulling my 8 off the road for an overhaul and one of the side projects is I will attempt to make some rocket bunny inspired flares and sticking some wide *** rims on im currently looking at the work CR-2P rims im going 11.5 on the back but im not sure how wide I can go on the from,
I think my flares are gonna be in the 50mm area but ive still gotta factor in the steering so I was wondering how wide others have gone on the fronts even without flares I know 9.5 on et38 fit nicely as thats what i have now nut if I just got straight to 10.5 will I have turning issues etc.
I think my flares are gonna be in the 50mm area but ive still gotta factor in the steering so I was wondering how wide others have gone on the fronts even without flares I know 9.5 on et38 fit nicely as thats what i have now nut if I just got straight to 10.5 will I have turning issues etc.
#4
Modulated Moderator
iTrader: (3)
I guess I would figure out what you want for flare width wise and then pick offset based on where you are moving the outer edge of the rim too and what you can get for wheels. If your flares are 2" wider on the front you could go to 10.5 with +10 or even smaller offset if you can get the wheels
Rears you will have no trouble getting 12's under if you cut the arches out.....
Rears you will have no trouble getting 12's under if you cut the arches out.....
Thread
Thread Starter
Forum
Replies
Last Post
Feffman
SE RX-8 Forum
1
10-21-2016 07:39 AM
Mr. Pockets
Series I Wheels, Tires, Brakes & Suspension
7
05-13-2016 12:17 PM
lude1888
West For Sale/Wanted
1
05-10-2016 05:51 AM
arvigovi
RX-8 Parts For Sale/Wanted
4
05-07-2016 01:52 AM
MC36
SE RX-8 Forum
0
05-05-2016 08:27 AM