DIY over fenders
#1
Registered
Thread Starter
DIY over fenders
Planning on running a 18x10.5 square set up for track purposes.
The wheels have a +15 offset and I'm running a set of 265/35/18 Hancock's, yes I said Hancock's cause I'm a Bridgestone man myself.
Just wondering if anyone on here has any experience making their own over fenders? Me and a buddy are going to take a shot at fabing up some prototypes to give me some more wheel room to fit these suckers.
I was looking into some sheet metal as its easy to cut and sturdy and whatnot but idk how easy it is to mold without using one of those roller ***** that costs hundreds if not thousands to buy.
Seen some fiberglass stuff made but it usually ends up looking like caked on **** so I'm not really into it.
Any info helps.
The wheels have a +15 offset and I'm running a set of 265/35/18 Hancock's, yes I said Hancock's cause I'm a Bridgestone man myself.
Just wondering if anyone on here has any experience making their own over fenders? Me and a buddy are going to take a shot at fabing up some prototypes to give me some more wheel room to fit these suckers.
I was looking into some sheet metal as its easy to cut and sturdy and whatnot but idk how easy it is to mold without using one of those roller ***** that costs hundreds if not thousands to buy.
Seen some fiberglass stuff made but it usually ends up looking like caked on **** so I'm not really into it.
Any info helps.
Thread
Thread Starter
Forum
Replies
Last Post
Touge
Canada Forum
0
09-20-2016 01:17 AM
Touge
Canada Forum
0
09-20-2016 01:16 AM