SoCal Lounge
12-07-2009, 11:07 PM
Tilt: 18x10 +50 something was the highest i ever heard of - mind you this was only heard. I know Team was fitting some 18x10's in like +48 offset IIRC. I would imagine 18x10.5 +50 would work.
12-08-2009, 12:22 AM
Administrator
iTrader: (7)
Zach,
here ya go http://tinyurl.com/yhz5pfh
here ya go http://tinyurl.com/yhz5pfh
12-08-2009, 12:23 AM
Administrator
iTrader: (7)
omg!
![mike[piston eater]'s Avatar](https://www.rx8club.com/avatars/mike%5Bpiston-eater%5D-48728.gif?dateline=1334247180)
12-08-2009, 12:33 AM
Registered
Join Date: Dec 2008
Location: Orange County, California
Posts: 895
Likes: 0
Received 0 Likes
on
0 Posts
Zach,
here ya go http://tinyurl.com/yhz5pfh
here ya go http://tinyurl.com/yhz5pfh
Haha thanks bud. Still didn't get too much out of that, just a bunch of other forums. But from what I did see it seems that shaving is just cutting the part of the fender that you'd roll? I don't see how thats worse than rolling?
12-08-2009, 12:36 AM
Administrator
iTrader: (7)
zach: yeah, shaving is where they cut off the inside of the fender instead of rolling it upwards.
some people don't like shaving because then that metal can rust and sometimes it stays sharp which can be bad if your tire rubs.
they both accomplish the same thing, just different ways of going about it.
some people don't like shaving because then that metal can rust and sometimes it stays sharp which can be bad if your tire rubs.
they both accomplish the same thing, just different ways of going about it.
Last edited by Jedi54; 12-08-2009 at 12:38 AM.
12-08-2009, 12:41 AM
Administrator
iTrader: (7)
I'm watcing I am Legend on HBO; this movie rocks.
