LFX_RX8
March 16, 2023
When pressing out hardware... 1) You need a blank that is the right size (matched to the part your pressing out) and 2) you need to be able the support the stationary hardware while limiting residual damage. This take some experimentation... but after some thought and jiggling, rotating, balancing, and supporting the axle hub is pressed out of the knuckle. This brings with it the center race of the wheel bearing. Note: The C-clip can't be removed as it is trapped by the hub.
More About This Picture
Vehicle
N/A
Location
N/A
Keywords
N/A
Discover More Pictures
See MoreAdvertisement
Be the first to comment on this picture!